5. Software Control - Lightware Device Controller
5.11.4. Backup
Details about this function can be found in the
5.11.5. System
Cleartext Login (Login Settings)
DIFFERENCE:
This feature is available only in UMX-TPS-TX140K and TX140-Plus models from FW
package v1.5.0b4.
This cleartext login tool allows setting a password, thus, the device will not accept any command coming
from a control interface (RS-232, Ethernet, etc...) without login. The device will be visible in the Device
Discovery window (as the device type and the serial number can be queried without login) but connection
can be established only after successful login. The login is valid until a TCP socket break in case of Ethernet
connection.
#login
ATTENTION!
If the login is enabled, the password will be asked when opening
INFO:
The login password is erased and the login is disabled when restoring the factory default values.
Configuration Cloning (Backup Tab)
section.
System tab in Settings menu
The Built-In Miniweb.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
Further functions
▪
Download system log - saving the file of the device.
Load factory defaults - recalling factory defaults settings and values. All factory default settings are
▪
listed in the
Factory Default Settings
▪
Reboot - rebooting the system.
section.
#factory
#log
#systemlog
#reboot #restart
80