Enable/Disable The Ethernet Port; Settings; Mode Setting; Parameters Settings - Lightware UMX-TPS-TX120 User Manual


  
6. LW2 Programmer's Reference
6.5.6. Enable/disable the Ethernet Port
Command and Response
ȩ {ETH_ENABLE=<switch>}
Ȩ (ETH_ENABLE=<switch>)CrLf
Parameters
If the <switch> parameter is 0, the port is disabled. If its value is 1, the port is enabled.
Example
ȩ {ETH_ENABLE=1}
Ȩ (ETH_ENABLE=1)
6.6. RS-232 Settings
6.6.1. RS-232 Mode Setting
RS -232 mode can be set as follows. See more details about RS -232 modes in the
#rs232 #rs-232 #serial #commandinjection
Command and Response
ȩ {RS232=<mode>}
Ȩ (RS232=<mode>)CrLf
Parameters
Parameter Parameter description
<mode> RS-232 operation mode
Example
ȩ {rs232=control}
Ȩ (RS232=CONTROL)
INFO:
The current RS-232 mode can be queried by the {RS232=?} command.
Serial Interface section.
Value Parameter value
CONTROL Control mode
CI Command injection mode
PASS Event Manager (Pass-through) mode
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
6.6.2. RS-232 Parameters Settings
The parameters of local RS -232 port can be set as follows.
Command and Response
ȩ {RS232_LOCAL_FORMAT=<BaudRate>;<DataBit>;<Parity>;<StopBit>}
Ȩ (RS232_LOCAL_FORMAT=<BaudRate>;<DataBit>;<Parity>;<StopBit>)CrLf
Parameters
Parameter
<BaudRate>
<DataBit>
<Parity>
<StopBit>
Example
ȩ {rs232_local_format=9600;8;O;X}
Ȩ (RS232_LOCAL_FORMAT=9600;8;O;X)
Explanation
RS -232 port is set as the following: the baud rate to 9600, data bit to 8, parity to odd, and stop bit is not
changed, remained 1.

INFO: The actual RS-232 parameters can be queried by the {RS232_LOCAL_FORMAT=?} command.
Parameter description Value
X No change
4800 4800
7200 7200
9600 9600
Baud rate 14400 14400
19200 19200
38400 38400
57600 57600
115200 115200
X No change
Data bit 8 8
9 9
X No change
N None
Parity
E Even
O Odd
X No change
1 1
Stop Bit
1,5 1,5
2 2
94
Parameter value