Query The Status Of Destination Port; Query The Video Crosspoint Setting; Disconnect Video Input; Switching Video Input - Lightware UMX-TPS-TX120 User Manual


  
7. LW3 Programmers' Reference
7.6.2. Query the Status of Destination Port
Command and Response #status
ç GET·/MEDIA/VIDEO/XP.DestinationPortStatus
pr·/MEDIA/VIDEO/XP.DestinationPortStatus=<out1_state>;<out2_state>;<...>;<out#_state>
æ
Parameters
<out#_state> The response contains 5 ASCII characters for each port. The first character indicates the
mute/lock state, the next 2-byte long HEX code showing the current state of the output port.
Example
ç GET /MEDIA/VIDEO/XP.DestinationPortStatus
æ pr /MEDIA/VIDEO/XP.DestinationPortStatus=M00BF
Legend
See at previous section.
Example and Explanation
M 0
0 0 0 0 0 0
Unlocked,
Muted
Reserved Reserved Reserved
7.6.3. Query the Video Crosspoint Setting
Command and Response
ç GET·/MEDIA/VIDEO/XP.DestinationConnectionList
pr·/MEDIA/VIDEO/XP.DestinationConnectionList=<in>
æ
Example
ç GET /MEDIA/VIDEO/XP.DestinationConnectionList
æ pr /MEDIA/VIDEO/XP.DestinationConnectionList=I1
7.6.4. Disconnect Video Input
Command and Response #crosspoint #switch
ç CALL·/MEDIA/VIDEO/XP:switch(0:<out>)
æ mO·/MEDIA/VIDEO/XP:switch
Example
ç CALL /MEDIA/VIDEO/XP:switch(0:O1)
æ mO /MEDIA/VIDEO/XP:switch
Input ports are disconnected from the O1 port.
0 B
0 0 1 0 1 1 1 1
No embedded Signal
Reserved Encrypted
audio presents
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
7.6.5. Switching Video Input
Command and Response
ç CALL·/MEDIA/VIDEO/XP:switch(<in>:<out>)
æ mO·/MEDIA/VIDEO/XP:switch
Example
ç CALL /MEDIA/VIDEO/XP:switch(I2:O1)
æ mO /MEDIA/VIDEO/XP:switch
Example 2
ç CALL /MEDIA/VIDEO/XP:switch(0:O1)
æ mO /MEDIA/VIDEO/XP:switch
When using 0 (zero) value as an input, the input will be disconnected and no signal will appear on the output.
7.6.6. Querying the Connected Input Port Number
DIFFERENCE:

package v1.5.0b4.
F
The response of this command shows the input port that is connected to the queried output port.
1 1
Command and Response
Connected
ç GET·/MEDIA/VIDEO/<out>.ConnectedSource
pr·/MEDIA/VIDEO/<out>.ConnectedSource=<in>
æ
Example
ç GET /MEDIA/VIDEO/O1.ConnectedSource
æ pr /MEDIA/VIDEO/O1.ConnectedSource=I1
#crosspoint #switch
This feature is available only in UMX-TPS-TX140K and TX140-Plus models from FW
#crosspoint
106