Connecting Steps; Fp/Wp-Umx-Tps-Tx100 Series; Umx-Tps-Tx100 Series - Lightware UMX-TPS-TX120 User Manual


  
3. Installation
3.5. Connecting Steps
3.5.1. FP/WP-UMX-TPS-TX100 series
CATx Connect the transmitter and a compatible receiver or the matrix input board by a CATx cable via the
TPS connectors.
VGA Connect the transmitter and the sources using the inputs and VGA / DVI-I / HDMI / DisplayPort
HDMI
cables.
DP
Audio Optionally connect an asymmetric audio device with unbalanced audio signal (e.g. a VGA laptop)
to the 2.5" TRS (jack) audio input port.
LAN Optionally connect the transmitter to a LAN network in order to control the device.
RS-232 Optionally connect a controller/controlled device (e.g. relay box) to the RS-232 port.
Power
See powering options in the next section.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
3.5.2. UMX-TPS-TX100 series
CATx Connect the transmitter and a compatible receiver or the matrix input board by a CATx cable via the
TPS connectors.
DVI DP
Connect the transmitter and the sources using the inputs and VGA / DVI-I / HDMI / DisplayPort
HDMI
cables.
VGA
Optionally connect an asymmetric audio device with unbalanced audio signal (e.g. a VGA laptop)
Audio
to the 2.5" TRS (jack) audio input port.
Audio Optionally connect a symmetric audio device with balanced audio signal (e.g. a media player) to
the 5-pole Phoenix audio input port. See the wiring guide for the connector in the
Guide section.
USB
Only for UMX-TPS-TX140K: Optionally for USB HID extension: connect the transmitter to the
computer by the USB-B cable and connect USB HID device(s) to the compatible receiver.
IR
Optionally for Infrared control:
- Connect the IR emitter to the IR OUT port of the device.
- Connect the IR detector to the IR IN port of the device.
LAN Optionally connect the transmitter to a LAN network in order to control the device.
RS-232 Optionally for RS-232 control: connect an external device (e.g. touch panel) to the RS-232 port.
GPIO Optionally connect a controller/controlled device (e.g. relay box) to the GPIO port.
Power
See powering options in the next section.
36
Cable Wiring