Lightware UMX-TPS-TX120 User Manual page 70


  
5. Software Control - Lightware Device Controller
Ports Section of the UMX-TPS-TX100 Series Devices
User can set the name and command injection port to each sources and destinations. For more details
about IR interface see the IR Interface section.
Infra tab - Ports window for the UMX-TPS-TX100 series devices
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
Ports Section of the UMX-TPS-TX140-Plus UMX-TPS-TX140K and WP-UMX-TPS-TX130-US Models
Infra tab - Ports window for the UMX-TPS-TX140-Plus model
The user can set the name and command injection port to each sources and destinations. For more details
about IR interface see the
is available in this section.
Sending pronto hex codes (Little-endian format)
Copy the raw, little endian-format IR code into the Send Pronto Hex entry field and click the Send button.
The maximum length of the code can be 765 characters (765 bytes). For more details about the accepted IR
code formats, see Sending Pronto Hex Codes in Little-endian Format via IR Port
This entry field does not store the code. The code can be saved into the action in the event manager with
the following parameters: Category: Infra; Expression: Send pronto hex; Port: D1; Pronto hex:
In the Event Manager, the maximum length of the code can be 184 characters (184 bytes).

INFO: Sending bigger endian-format code is available with LW3 protocol command, see
Hex Codes in Big-endian Format via IR Port
Clear all IR codes
Clicking on the button results deleting all stored IR fingerprints.
IR Interface section. The message sending function (little-endian pronto hex code)
#commandinjection
section.
70
section.
<custom_code>
Sending Pronto