Special Maintenance For Low Or High Volume Usage - Kodak X-Omat 2000 Operator's Manual

OPERATORS MANUAL
Cleaning the Replenishment Strainer Assemblies
Figure 15
[18] Clean the Replenishment Strainers when mixing new chemicals.
(a) Place Pinch Clamps on The tubing to stop the replenishment flow.
(b) Disassemble the Strainer Assemblies.
(c) Use a brush and warm water to clean the Strainer Assemblies and to remove dirt and chemical deposits
from the Screens.

Special Maintenance for Low or High Volume Usage

If the processor handles a low volume, less than 25 sheets of film per day, do this procedure every 2 weeks.
If the processor handles a high volume, more than 25 sheets of film per day, do this procedure monthly.
[1] Use the Procedure on Page
[2] Flush the developer and fixer Tanks with clean water.
[3] Install the Weirs, red for developer and blue for fixer.
[4] To fill the fixer Tank, add fixer replenisher until the solution is at the higher Fill Line on the blue Weir.
[5] To fill the processor developer Tank:
(a) Add 190 mL (6.5 fl oz) of Kodak RP X-Omat Developer Starter.
(b) Fill the developer Tank to the higher Fill Line on the red Weir with developer-replenisher solution.
18
8 to drain the Tanks.
STRAINER ASSEMBLY
SCREEN
H172_1009BCA
19JAN99 – 7C8770
H172_1009BC