Table of Contents
Advertisement
Replenishment Volume
7E6174 – 16FEB01
Replenishment volume changes are stored for the cycle until new changes are made.
Replenishment volume is dependent on the replenishment mode: Automatic or
Flooded.
In the Automatic Replenishment mode, replenishment solutions are added when an
area of film equivalent to approximately 1500 cm
example, one 35 x 43 cm (14 x 17 in.) sheet of film.
As film usage for the Processor decreases, the volumes of developer and fixer
necessary for correct replenishment increase.
Film Usage
Low
1 - 2
Medium
3 - 4
High
5 (or more)
*default value
Enter the volume for the Developer and Fixer Replenishment on the keypad for high
film usage.
The Microprocessor automatically calculates the replenishment volumes for low and
medium film usage.
In the Flooded Replenishment mode, default developer and fixer replenishment
volumes are:
• 65 ml every 5 minutes and
• 65 ml for each 1500 cm
Note
Before changing the replenishment volumes, do a replenishment calibration.
To change the replenishment volumes from the factory default setting:
1. Press GO TO SETUP.
PROCESSOR READY
127.4 F = DRYER TEMP
DISPLAY
TIME/
FIX TEMP
DATE
H186_8522AC
2
(240 in.
Films/
1/2 hour
(Auto) Replenishment Volume
Developer
(/sheet)
92
73
55*
2
2
(240 in.
) of film
STD
95.0 F = DEV TEMP
GO TO
DONE/
SETUP
RETURN
Key Operator Instructions
2
) has been processed, for
113
95
80*
5–47
Advertisement
Table of Contents
