Resilient Pressure Drive Roller (Wash Rack); Removing And Replacing The Drive Roller - Kodak M6B Service Manual

Resilient Pressure Drive Roller (Wash Rack)

Removing and Replacing the Drive Roller

[1] Remove the following:
• TIE ROD SHAFTS
• SCREWS, WASHERS, GEAR, SPACERS, and BEARINGS from the outside of both SIDE PLATES.
See Figure 14.
[2] Rotate the KEYWAY to the up position. See Figure 14.
[3] Pull the ROLLER to the non-drive side and remove the KEY from the SPROCKET.
[4] Remove the 2 SPRINGS.
[5] Pull the ROLLER to the drive side. Flex the SIDE PLATE to allow removal of the ROLLER.
[6] Reverse the procedure to assemble.
Figure 14 Disassembling the Resilient Pressure Drive Roller from the Wash Rack
246628
SPRING
PIN
SPRING
SPACER
KEY
SPACER
GEAR
BEARING
WASHER
LOCK WASHER
LOCK WASHER
KEY
SCREW
WASHER
SCREW
H048_0127DCB
H048_0127DA
2-11