Resilient Drive Rollers In The Wash Rack - Kodak X-Omat 2000 Service Manual

[7] Remove the DRIVE ROLLER.
[8] Reverse the steps to install a new DRIVE ROLLER.

RESILIENT DRIVE ROLLERS in the WASH RACK

H172_0632DCA
H172_0632DA
[1] Remove from the TIE ROD:
• 2 SCREWS
• ID WASHER
[2] Remove from the ends of DRIVE ROLLER and DRIVEN ROLLER outside of the SIDE PLATES:
• SCREWS
• WASHERS
• DRIVE GEAR
• SPACERS
• BEARINGS
[3] Rotate the flat part of the SHAFT to the up position.
[4] Remove the 2 SPRINGS.
[5] Move the 2 SHAFTS of the DRIVE ROLLER and the DRIVEN ROLLER towards the non-drive SIDE PLATE.
[6] Bend the SIDE PLATE a small distance and remove the ends of the 2 SHAFTS.
7C8772 – 12JAN99
RESILIENT
DRIVE
TIE
ROLLER
ROD
PIN
SHAFT
2 SPRINGS
SPROCKET
DRIVEN
ROLLER
SHAFT
SIDE PLATE
SPACER
KEY
THRUST
WASHER
PIN
SPACER
BEARING
WASHER
Adjustments and Replacements
ID WASHER
2 SCREWS
SPACER
DRIVE
GEAR
KEY
SCREW
SCREW
13