Replacement Of Film Pocket Clutch Spring For Ml700; Plus And For Ml700 With Modification 19 Installed - Kodak MULTILOADER 700 Service Manual

REPLACEMENTS
11
Mount the MAGAZINE EMPTY SENSOR BRACKET.
12
. Mount the LEFT HAND FILM HOLDER.
13
. Insert an empty MAGAZINE without a COVER into MAGAZINE POSITION 4.
14
. Power up ML700
15
. Enter SERVICE MODE FDAB DAY,DAY,9,9
16
. Select OPTION 7.8.1 (FILM POCKET)
17
. Transport FILM POCKET to MAGAZINE LEVEL 4.
18
. Select OPTION 7.7 (MAGAZINE SUCKER BAR)
19
. Press KEY 1 until FILM POCKET MOTOR M7 stops. The FILM POCKET DRIVE
SHAFT with its TIMING DISKS is now in MAGAZINE SUCKER BAR IN position.
20
. Carefully rotate the MAGAZINE SUCKER BAR ARM upwards until it is in a vertical
position. Then tighten the MAGAZINE SUCKER BAR ARM MOUNTING SCREW.
21
. Check the FILM POCKET ADJUSTMENTS.
22
. Leave the SERVICE MODE
23
. Key in 3585 to bring all MOTORS into HOME POSITION.
24
. MOUNT the COVER onto the MAGAZINE.

REPLACEMENT OF FILM POCKET CLUTCH SPRING for ML700

Plus and for ML700 with Modification 19 installed.

1
. Power down ML700.
2
. Unplug ML700.
3
. Separate ML700 from PROCESSOR.
4
. Take off REAR PANEL from ML700.
KODAK AG, Stuttgart 2-33
3053-3
12/1998