Connecting A Usb Memory To The Computer Unit - ABB IRC5 Product Manual

2 Installation and Commissioning, IRC5

2.7.2. Connecting a USB memory to the computer unit

2.7.2. Connecting a USB memory to the computer unit
Location DSQC639
A USB memory may be connected to either one of the USB portson the computer unit. The
location of the USB ports is shown by the following illustration:
xx0600002895
A
Connection
102
USB 1, 2 The USB connectors provide two legacy USB 2.0 ports supporting High
Speed/Full Speed/Low Speed (HS/FS/LS)
Action
1. Open the connector cover on the controller
or open the door, (Control Module on the
Dual Cabinet).
2. Remove the end cover on the USB
memory and connect it to the connector.
Do not disconnect the USB memory within
approx. 10 seconds after connecting it.
Info/illustration
xx0600002894
• A: USB port
The USB memory and its contents may
now be accessed from the computer unit
just as any other hard drive unit.
Continues on next page
3HAC021313-001 Revision: P