ABB IRC5 Product Manual page 279

Refitting
The procedure below details how to refit the power distribution board.
3HAC021313-001 Revision: P
Action
1.
DANGER!
Before commencing any work inside the
cabinet, please observe the safety
information in section DANGER - Make
sure that the main power has been
switched off! on page 30.
2. Refit the new power distribution board by
pushing it leftward to fit the left screw
head.
Refit the right screw.
3. Lock the unit in place by tighten the
attachment screws.
4. Reconnect the connectors X1 - X9.
CAUTION!
Hot surface on top of the power distribu-
tion board unit.
Do not route or place cables on top of the
power distribution board.
4 Repair activities, controller IRC5
4.29.2. Replacement of power distribution board
Note/Illustration
xx070000122
• A: left attachment screw
• B: right attachment screw
Continued
277