Memory Unit; Transferring The Memory Unit - ABB ACS880-07 Hardware Manual

Memory unit

When a drive is replaced, the parameter settings can be retained by transferring the
memory unit from the defective drive to the new drive. The memory unit is located on the
control unit, see page

Transferring the memory unit


WARNING! Obey the instructions in chapter
them, injury or death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section
18 before you start the work.
2. Undo the memory unit mounting screw and take the memory unit out. Replace the unit
in reverse order. Note: For frames R6 to R9, there is a spare screw next to the
memory unit slot.
R6...R9
138 or 148.
R10, R11
Safety instructions. If you ignore
Precautions before electrical work
Maintenance 193
on page