Installation Of Dispensepac Support - ABB IRC5 Product Manual

2.9.14. Installation of DispensePac support

About DispensePac
To use the DispensePac option you need to connect externally placed Process I/O board(s).
The procedure below shows how to connect the DeviceNet cable from the Process I/O board
to the DeviceNet signal cable from the Process Interface Board.
Location
The illustration below shows the location of the Process Interface Board and the connection
point of the DeviceNet cable(s).
xx0900000130
A
B
Connecting Process I/O boards
3HAC021313-001 Revision: P
Process Interface Board
A57.X1 and A57.X2 DeviceNet connectors
Action
1. The DeviceNet cable from the Process I/O board
(not included in the DispensePac support option) is
connected (without termination resistance) to the
DeviceNet cable, marked A57.XT1/XT2, from the
Process Interface Board.
Information about connection of the leaders is found
in the Circuit diagram 3HAC024480-004
2. If a second Process I/O board is to be connected,
remove the termination resistance on the second
cable and connect the second Process I/O board to
this cable.
2 Installation and Commissioning, IRC5
2.9.14. Installation of DispensePac support
Note
The connectors A57.XT1 and
A57.XT2 are found on the bottom
of the Controller cabinet, at the
end of the cable from the Process
Interface Board.
165