Preventive Maintenance Checks; Electrical Checks - Planmeca Proline XC Technical Manual

Chapter F - PREVENTIVE MAINTENANCE

2 PREVENTIVE MAINTENANCE CHECKS

2.1 Electrical checks

Annually or after every 10 000 exposures whichever appears first the electrical exposure
parameters of the Planmeca Proline XC Panoramic X-ray unit should be checked in order to
maintain the initially accurate operation of the equipment despite of the possible long term
component value alterations.
There are no adjustments in the equipment because of its self-calibrating microprocessor
based operation and therefore no actual parameter trimming of the kV, mA and exposure time
can be done. If one of the parameters to be checked by this periodical preventive mainte-
nance procedure is found to be beyond the limit values allowed, the corresponding electrical
circuit board is to be changed in whole and sent back to the factory for recalibration that is
done by replacing the faulty component.
The parameters to be checked are the following:
Before exposure:
•
•
During exposure:
•
•
•
In order to perform the calibration measurements the X-ray equipment must be powered off
and the rotating arm bottom cover and Generator EMC-cover are to be removed. The cable
connector is disconnected from PSU board connector J1. The multimeter is connected
between the cable connector J1 and ground.
Before powering on the X-ray equipment the circuit impedance measurements should be per-
formed in order to verify the condition of the measurement resistors in the tube head.
Select resistor mode of the multimeter.
kV circuit impedance measurement
The multimeter is connected between the connector J1: 7 and tube head ground. Read the
multimeter display.
Acceptable value between J1: 7 and tube head ground is from 18.60 kohms to 19.0 kohms.
F-2 Planmeca Proline XC X-ray unit
kV measurement circuit impedance
mA measurement circuit impedance
kV value
mA value
exposure time
PREVENTIVE MAINTENANCE CHECKS
Technical Manual