Z-Carriage Cover; Upper Shelf Cover; Motors; Z-Motor - Planmeca Proline XC Technical Manual

MOTORS

1.6 Z-carriage cover

a)
b)
c)
d)

1.7 Upper shelf cover

a)
b)
c)
d)
2 MOTORS

2.1 Z-motor

a)
b)
c)
d)
e)
f)
g)
h)
i)
2.2 Rotating motor & gear
a)
b)
c)
d)
e)
f)
g)
Technical Manual
Remove the cover of the lower shelf.
Remove the connectors
Remove the lower shelf.
Remove the cover.
Remove the rotating part.
Remove the connectors of the sagittal light.
Remove the fixing screws of the cover.
Remove the cover.
Lock the rotating unit and the Z-carriage with transportation pins
Place a support on the floor where you can tilt the machine.
Detach the unit from the wall and overturn it carefully on the support.
Pull the top trim cover out.
Remove the steel cables and connectors.
Slack the stop screws on the drawing side of the motor axle.
Slack the stop screw on the sliding side and pull the steel cable off.
Cut the panduit and pull the motor away.
Install a new motor.
Remove the cover of rotating part.
Remove the Generator processor PCB from its holders.
Remove the loading spring.
Remove the connector.
Remove the phillips screw from the end of the axle.
Remove the motor/gear package.
Remove the spring nipple and plastic bushing from the gear.
Chapter H - PARTS REPLACEMENT & REPAIR
Planmeca Proline XC X-ray unit H-5