Planmeca Proline XC Technical Manual page 45

ERROR MESSAGES
ERROR CODE
Er 57
Er 60
Er 61
Er 62
Er 64
Er 65
Er 70
Er 71
Er 72
Er 73
Er 74
Er 75
Er 80
Er 81
Er 82
Er 83
Er 84
Er 85
Er 86
Er 87
Er 90
Er 91
Er 99
Technical Manual
Exposure button activated when the unit is turned on.
Generator processor power too low.
Processor communication error.
Limit sensor power missing.
The radiation reaching the AEC sensor is very low or missing completely.
The radiation reaching the AEC sensor is too high.
Processor communication error.
Generator processor program memory failure.
Keyboard processor program memory failure.
Keyboard processor program error.
Keyboard processor operating improperly.
Keyboard processor operating improperly.
Keyboard processor EEPROM failure.
Generator processor EEPROM failure.
Keyboard processor configuration error.
Generator processor configuration error.
Tube power generator time out.
PSU PCB internal voltage too low.
Digital X-ray unit with two fixed sensor heads: Sensor head in wrong position.
PSU PCB heat sink temperature too high.
Keyboard processor EEPROM not activated.
Keyboard processor stack overflow.
Error code generation error.
Chapter C - HELP & ERROR MESSAGES
ERROR MESSAGE EXPLANATION
Planmeca Proline XC X-ray unit C-3