Information Center Configuration; Introduction To The Information Center Configuration Tasks - 3Com WX3000 Series Operation Manual

You can use the sysname command to modify the system name. Refer to the System Maintenance and
Debugging part of this manual for details)
Note that there is a space between the sysname and module fields.
Module
The module field represents the name of the module that generates system information. You can enter
the info-center source ? command in system view to view the module list. Refer to
module name and description.
Between "module" and "level" is a "/".
Level (Severity)
System information can be divided into eight levels based on its severity, from 1 to 8. Refer to
for definition and description of these severity levels. Note that there is a forward slash "/" between the
level (severity) and digest fields.
Digest
The digest field is a string of up to 32 characters, outlining the system information.
Note that there is a colon between the digest and content fields.
Content
This field provides the content of the system information.
The above section describes the log information format sent to a log host by the device. Some log host
software will resolve the received information as well as its format, so that you may see the log format
displayed on the log host is different from the one described in this manual.

Information Center Configuration

Introduction to the Information Center Configuration Tasks

Complete the following tasks to configure the information center:
Configuring Synchronous Information Output
Configuring to Display the Time Stamp with the UTC Time Zone
Setting to Output System Information to the Console
Setting to Output System Information to a Monitor Terminal
Setting to Output System Information to a Log Host
Setting to Output System Information to the Trap Buffer
Setting to Output System Information to the Log Buffer
Task
1-6
Table 1-3 for
Table 1-1
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional