Re-Connecting The Network; Adjusting Wlan Setting; Adjusting Network Setting; Setting Serial Port Baud Rate - Christie Inspire Series User Manual

Re-connecting the network

After the network is disconnected and timeout using RJ-45/HDBaseT/Wifi, the browser refreshes the
page automatically and show HTTP404 (Not Found) error message.
If user wants to re-control the projector, the user must login in the control page with the account
and password again.

Adjusting WLAN setting

Set up network configuration for wireless networking.
1. Select Menu > Configuration > Communications > WLAN.
2. Set up the appropriate setting:
• SSID—Display the SSID of the wireless network.
• Enable—Enable or disable the wireless functionality.
• Start IP—Assign the start IP address of the wireless network.
• End IP—Assign the end IP address of the wireless network.
• Subnet Mask—Assign the subnet mask of the wireless network.
• Default Gateway—Assign the gateway of the wireless network.
3. To apply the WLAN settings, select Apply.

Adjusting network setting

Set up network configuration setting, such as reset back to default.
1. Select Menu > Configuration > Communications > Network.
2. Set up the appropriate network setting:
• Show Network Message—Enable or disable to display of the network message.
• Reset to Default—Reset the network configuration setting, including LAN setting and
• WLAN setting, back to default.
3. To apply the network configuration, select ENTER.

Setting serial port baud rate

Select the serial port and baud rate.
1. Select Menu > Configuration > Communications > Serial Port Baud rate.
2. Set up the appropriate baud rate.
3. To confirm the selection, select ENTER.
Inspire Series 4K User Manual
020-002098-01 Rev. 1 (09-2023)
Copyright © 2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring communications
60