Table of Contents
Advertisement
Adjusting WLAN setting
Set up network configuration for wireless networking.
1. Select MENU > Configuration > Communications > WLAN.
2. Set up the appropriate setting:
•
SSID—Display the SSID of the wireless network.
•
Enable—Enable or disable the wireless functionality.
•
Start IP—Assign the start IP address of the wireless network.
•
End IP—Assign the end IP address of the wireless network.
•
Subnet Mask—Assign the subnet mask of the wireless.
•
Default Gateway—Assign the gateway of the wireless.
3. To apply the WLAN settings, select Apply.
Adjusting network setting
Set up network configuration setting, such as reset back to default.
1. Select MENU > Configuration > Communications > Network.
2. Set up the appropriate network setting:
•
Show Network Message—Enable or disable to display of the network message.
•
Reset to Default—Reset the network configuration setting, including LAN setting and
WLAN setting, back to default.
3. To apply the network configuration, select ENTER.
Setting serial port baud rate
Select the serial port and baud rate.
1. Select MENU > Configuration > Communications > Serial Port Baud rate.
2. Set up the appropriate baud rate.
3. To confirm the selection, select ENTER.
Enabling serial port echo
Enable or disable to allow the CLI command pass through.
1. Select MENU > Configuration > Communications > Serial Port Echo.
2. To swap, select ENTER.
Inspire Series Installation and Setup Guide
020-002097-01 Rev. 1 (11-2023)
Copyright ©2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring light settings
31
Advertisement
Table of Contents
