Adjusting Network Setting; Setting Serial Port Baud Rate; Enabling Serial Port Echo - Christie HS 2K Series User Manual

2. Set up the appropriate setting:
• SSID—Displays the SSID of the wireless network.
• Enable—Enables or disables the wireless functionality.
• Start IP—Assigns the start IP address of the wireless network.
• End IP—Assigns the end IP address of the wireless network.
• Subnet Mask—Assigns the subnet mask of the wireless.
• Default Gateway—Assigns the gateway of the wireless.
3. To apply the WLAN settings, select Apply.

Adjusting network setting

Set up network configuration setting, such as reset back to default.
1. Select Menu > Configuration > Communications > Network.
2. Set up the appropriate network setting:
• Show Network Message—Enables or disables to display of the network message.
• Reset to Default—Resets the network configuration setting, including LAN setting and
WLAN setting, to default.
3. To apply the network configuration, select ENTER.

Setting serial port baud rate

Select the serial port and baud rate.
1. Select Menu > Configuration > Communications > Serial Port Baud rate.
2. Set up the appropriate baud rate.
3. To confirm the selection, select ENTER.

Enabling serial port echo

Enable or disable to allow the CLI pass through.
1. Select Menu > Configuration > Communications > Serial Port Echo.
2. To swap, select ENTER.
HS Series 2K User Manual
020-002040-01 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring communications
60