Service Access Control Screen; Figure 115 Snmp - ZyXEL Communications IES-612-51A User Manual

Figure 115 SNMP

The following table describes the labels in this screen.
Table 76 SNMP
LABEL
Return
Get Community
Set Community
Trap Community
Trap Destination
1~4
Port
Trusted Host
Apply
Cancel

34.5 Service Access Control Screen

To open this screen, click Advanced Application, Access Control, Service Access Control.
IES-612-51A User's Guide
DESCRIPTION
Click Return to go back to the previous screen.
Enter the get community, which is the password for the incoming Get- and
GetNext- requests from the management station.
Enter the set community, which is the password for incoming Set- requests from
the management station.
Enter the trap community, which is the password sent with each trap to the
SNMP manager.
Enter the IP address of a station to send your SNMP traps to.
Enter the port number upon which the station listens for SNMP traps.
A "trusted host" is a computer that is allowed to use SNMP with the IES-612-
51A.
0.0.0.0 allows any computer to use SNMP to access the IES-612-51A.
Specify an IP address to allow only the computer with that IP address to use
SNMP to access the IES-612-51A.
Click Apply to save your changes to the IES-612-51A's volatile memory. The
IES-612-51A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 34 Access Control
229