Dsl Port Profile Set Command; Figure 215 Dsl Profile Show Command Example - ZyXEL Communications IES-612-51A User Manual

The following example displays the DSL DEFVAL profile.

Figure 215 DSL Profile Show Command Example

ras> adsl profile show DEFVAL
01. DEFVAL
max rate
min rate
latency delay (ms):
max margin
min margin
target margin (db):
up shift margin(db):
down shift margin(db):

52.1.5 DSL Port Profile Set Command

Syntax:
ras> adsl profile set <profile> <fast|interleave[=<up delay>,<down delay>]>
<up max rate> <down max rate>
[<up target margin> <up min margin> <up max margin> <up min rate>
<down target margin> <down min margin> <down max margin> <down min rate>
<up down-shift margin> <up up-shift margin>
<down down-shift margin> <down up-shift margin>]
where
<profile>
<fast|interleav
e[=<up
delay>,<down
delay>]>
<up max rate>
<down max rate> =
<up target
margin>
<up min margin> =
<up max margin> =
<up min rate>
<down target
margin>
<down min
margin>
IES-612-51A User's Guide
latency mode: interleave
up stream down stream
--------- -----------
(kbps): 512
(kbps): 32
4
(db): 31
(db): 0
6
9
3
The descriptive name for the profile.
=
The latency mode. With interleave, you must also define the
=
upstream and downstream delay (1-255 ms). It is
recommended that you configure the same delay for both
upstream and downstream.
The maximum DSL upstream transmission rate (64-4096
=
Kbps).
The maximum DSL downstream transmission rate (64-
32000 Kbps).
The target DSL upstream signal/noise margin (0-31db).
=
The minimum acceptable DSL upstream signal/noise
margin (0-31db).
The maximum acceptable DSL upstream signal/noise
margin (0-31db).
The minimum DSL upstream transmission rate (32-4096
=
Kbps).
The target DSL downstream signal/noise margin (0-31db).
=
The minimum acceptable DSL downstream signal/noise
=
margin (0-31db).
Chapter 52 ADSL Commands
2048
32
4
31
0
6
9
3
345