Vlan Set Command; Figure 152 Vlan Cpu Set Command Example - ZyXEL Communications IES-612-51A User Manual

where
<portlist>
<priority>
This command sets the priority of incoming frames with an IEEE 802.1Q VLAN tag.
The following example sets a priority of three for frames (with an IEEE 802.1Q VLAN tag)
that come in on DSL port 2.

Figure 152 VLAN CPU Set Command Example

ras> switch vlan priority 2 3

45.4.4 VLAN Set Command

Syntax:
ras> switch vlan set <vid> <portlist>:<F<T|U>|X|N> [<portlist>:<F<T|U>|X>
...][name]
where
<vid>
<portlist>
<F<T|U>|
|X|N>
[name]
This command adds or modifies an entry in the static VLAN table. Use the
command to display your configuration. An example of a configuration is shown next.
show
IES-612-51A User's Guide
Chapter 45 IEEE 802.1Q Tagged VLAN Commands
You can specify a single port: <1>, all ports: <*>, a list of
=
ports: <1,3,enet1>, you can also include a range of ports:
<1,5,6~10,enet1,enet2>.
= This is the priority value (0 to 7) to use for incoming frames
with an IEEE 802.1Q VLAN tag.
The VLAN ID [1 – 4094].
=
You can specify a single port: <1>, all ports: <*>, a list of
=
ports: <1,3,enet1>, you can also include a range of ports:
<1,5,6~10,enet1,enet2>.
The <F> stands for a fixed registrar administration control
=
flag and registers a <port #> to the static VLAN table with
<vid>.
For a fixed port, you also have to specify <T|U>, the tag
control flag.
<T> has the device add an IEEE 802.1Q tag to frames going
out through this port(s).
<U> has the device send frames out through this port(s)
without an IEEE 802.1Q tag.
This is the registrar administration control flag.
=
<X> stands for forbidden and blocks a <port #> from
joining the static VLAN table with <vid>.
<N> stands for normal and confirms registration of the
<port #> to the static VLAN table with <vid>. This is used
in GVRP applications.
A name to identify the SVLAN entry.
=
switch vlan
301