where
<bandwidth>
This command sets the default bandwidth for multicast channels for which you have not
configured bandwidth requirements yet. Multicast bandwidth settings on channels (using the
switch igmpsnoop bandwidth set
setting.
47.4.2 IGMP Bandwidth Set Command
Syntax:
ras> switch igmpsnoop bandwidth set <index> <start-mcast-ip> <end-mcast-ip>
<bandwidth>
where
<index>
<start-mcast-
ip>
<end-mcast-ip>
<bandwidth>
This command configures bandwidth allocation for the multicast channel(s). For multicast
channel(s) for which you have not configured bandwidth settings, the default multicast
bandwidth setting applies (see the
47.4.3 IGMP Bandwidth Delete Command
Syntax:
ras> switch igmpsnoop bandwidth delete <index>
where
<index>
This command removes the specified multicast bandwidth configuration profile.
47.5 IGMP Bandwidth Port Commands
Use the IGMP bandwidth port commands to set up bandwidth budgets for multicast traffic on
specific ports.
IES-612-51A User's Guide
Allowed bandwidth between 1 and 1000 000 kbps (kilo bits
=
per second).
command) have higher priority over this default
=
1..96; a unique number for this setting.
224.0.0.0..239.255.255.255; the beginning of the multicast
=
range.
=
224.0.0.0..239.255.255.255; the end of the multicast range.
It must be greater than <start-mcast-ip>.
1..100000, in units of kbps
=
switch igmpsnoop bandwidth default
1..96; a unique number for this setting.
=
Chapter 47 IGMP Commands
command).
317