Radius Screen; Figure 86 Radius; Table 52 Radius - ZyXEL Communications IES-612-51A User Manual

Chapter 23 Port Authentication

23.2 RADIUS Screen

To open this screen, click Advanced Application, Port Authentication.

Figure 86 RADIUS

The following table describes the labels in this screen.

Table 52 RADIUS

LABEL
802.1x
Enable
Authentication
Server
IP Address
UDP Port
Shared Secret
Apply
Enable Local Profile
Setting
Name
Password
182
DESCRIPTION
Click 802.1x to configure individual port authentication settings (see
23.3 on page 183).
Select this check box to have the IES-612-51A use an external RADIUS server
to authenticate users.
Enter the IP address of the external RADIUS server in dotted decimal notation.
The default port of the RADIUS server for authentication is 1812. You need not
change this value unless your network administrator instructs you to do so.
Specify a password (up to 31 alphanumeric characters) as the key to be shared
between the external RADIUS server and the switch. This key is not sent over
the network. This key must be the same on the external RADIUS server and the
switch.
Click Apply to save your changes to the IES-612-51A's volatile memory. The
IES-612-51A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Select this check box to have the IES-612-51A use its internal database of user
names and passwords to authenticate users.
Type the user name of the user profile.
Type a password up to 31 characters long for this user profile.
Section
IES-612-51A User's Guide