Dsl Port Loopback Command; Dsl Port Upstream Psd Command; Figure 221 Dsl Port Tel Command Example; Figure 222 Dsl Port Loopback Command Example - ZyXEL Communications IES-612-51A User Manual

where
<portlist>
<tel>
This command records the telephone number of a DSL subscriber telephone number.
The following example records the telephone number 12345678 for DSL port 5.

Figure 221 DSL Port Tel Command Example

ras> adsl tel 5 12345678

52.1.10 DSL Port Loopback Command

Syntax:
ras> adsl loopback <portlist> < f5> <vpi> <vci>
where
<portlist>
< f5>
<vpi> <vci>
This command has the IES-612-51A perform an OAMF5 loopback test on the specified DSL
port(s).
The following example has the IES-612-51A perform an OAMF5 loopback test on DSL port
1's PVC at VPI 0 and VCI 33.

Figure 222 DSL Port Loopback Command Example

ras> adsl loopback 1 f5 0 33
port[1] OAM F5 loopback test: failed

52.1.11 DSL Port Upstream PSD Command

Syntax:
ras> adsl usnompsd <portNo> [<max nominal psd>]
IES-612-51A User's Guide
You can specify a single DSL port <1>, all DSL ports <*> or
=
a list of DSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
= a DSL subscriber's telephone number. You can use up to 15
ASCII characters (including spaces and hyphens).
You can specify a single DSL port <1>, all DSL ports <*>
=
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
Use f5 to perform an OAMF5 loopback test on the specified
=
DSL port. An Operational, Administration and Maintenance
Function 5 test is used to test the connection between two
DSL devices. First, the DSL devices establish a virtual
circuit. Then the local device sends an ATM F5 cell to be
returned by the remote DSL device (both DSL devices must
support ATM F5 in order to use this test).
= When you perform an OAMF5 loopback test, specify a VPI/
VCI.
Chapter 52 ADSL Commands
349