Figure 78 Mvlan Setup; Table 44 Mvlan Setup - ZyXEL Communications IES-612-51A User Manual

Figure 78 MVLAN Setup

The following table describes the labels in this screen.

Table 44 MVLAN Setup

LABEL
MVLAN Status
MVLAN Group
VID
Active
Name
Delete
Cancel
Active
Name
VLAN ID
Port
IES-612-51A User's Guide
DESCRIPTION
Click MVLAN Status to open the MVLAN Status screen where you can view a
summary of all multicast VLAN on the IES-612-51A (see
165).
Click MVLAN Group to open the MVLAN Group screen where you can
configure ranges of multicast IP addresses for each multicast VLAN (see
Section 19.4 on page 168).
This field shows the VLAN ID of each multicast VLAN. Click it to edit its basic
settings and port members in the fields below.
This field shows whether this multicast VLAN is active (Yes) or inactive (No).
This field shows the name of this multicast VLAN.
Select the check boxes of the rule(s) that you want to remove in the Delete
column and then click the Delete button.
You cannot delete a VLAN if any PVIDs are set to use the VLAN or the VLAN is
the CPU (management) VLAN.
Click Cancel to begin configuring the fields afresh.
Select this if you want the multicast VLAN to be active. Clear this if you want the
multicast VLAN to be inactive.
Enter a descriptive name for the multicast VLAN. The name can be 1-31
printable ASCII characters long. Spaces are not allowed.
Enter the VLAN ID of the multicast VLAN; the valid range is between 1 and
4094.
This field displays each port number.
Chapter 19 Multicast VLAN
Section 19.2 on page
167