Tls Pvc Show Command; Figure 287 Tls Pvc Set Command Example; Figure 288 Tls Pvc Show Command Example - ZyXEL Communications IES-612-51A User Manual

<vci>
<DS vcprofile
[,US
vcprofile]>
<pvid>
<priority>
This command sets the second VLAN tag to add to the packets from the PVC.
The following example adds VLAN tag
( ) on port
1/33

Figure 287 TLS PVC Set Command Example

ras> adsl tlspvc set 2 1 33 DEFVAL 100 0

53.9.3 TLS PVC Show Command

Syntax:
ras> adsl tlspvc show <portlist> [<vpi> <vci>]
where
<portlist>
<vpi>
<vci>
This command displays the TLS settings for the specified port(s) or PVC(s). The following
example shows the TLS settings on port 2.

Figure 288 TLS PVC Show Command Example

ras> adsl tlspvc show 2
port vpi
---- --- ----- ----- --- ----------------------------------
2 1
IES-612-51A User's Guide
The VCI of the TLS PVC.
=
Assign a VC profile to use for this channel's downstream
=
traffic shaping.
Assign a VC profile to use for policing this channel's
=
upstream traffic. The IES-612-51A does not perform
upstream traffic policing if you do not specify an upstream
VC profile.
1 – 4094; the (second) VLAN Identifier to add to Ethernet
=
frames that the system routes using this PVC.
= Set the IEEE 802.1p priority (0~7) to add to the traffic that
uses this PVC.
.
2
The port number of the TLS PVC. You can specify a single
=
DSL port <1>, all DSL ports <*> or a list of DSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
The VPI of the TLS PVC.
=
The VCI of the TLS PVC.
=
vci pvid pri DS/US vcprofile
33 100 0 DEFVAL
Chapter 53 Virtual Channel Management Commands
to traffic using the
100 DEFVAL
ATM profile on PVC
397