Chapter 29 DSCP
Table 65 DSCP Setup (continued)
LABEL
Select
Active
Inactive
All
None
29.3 DSCP Map Screen
Use this screen to convert DSCP priority to IEEE 802.1p priority. To open this screen, click
Advanced Application, DSCP, DSCP Map.
Figure 105 DSCP Map
The following table describes the labels in this screen.
Table 66 DSCP Map
LABEL
DSCP Map
Source DSCP
802.1P Priority
Apply
210
DESCRIPTION
Select this, and click Active or Inactive to enable or disable the DSCP on this
port.
Click this to enable DSCP on the selected ports.
Click this to disable DSCP on the selected ports.
Click this to select all entries in the table.
Click this to un-select all entries in the table.
DESCRIPTION
Click DSCP Setup to open the screen where you can activate or deactivate
DSCP on each port (see
Section 29.2 on page
This field displays each DSCP value.
Enter the IEEE 802.1p priority to which you would like to map this DSCP value.
Click Apply to save your changes to the IES-612-51A's volatile memory. The
IES-612-51A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
209).
IES-612-51A User's Guide