Bandwidth Port Setup Screen; Figure 71 Bandwidth Port Setup - ZyXEL Communications IES-612-51A User Manual

Table 36 IGMP Bandwidth (continued)
LABEL
Apply
Index
Start Multicast IP
End Multicast IP
Bandwidth
Apply
Cancel
Index
Start Multicast IP
End Multicast IP
Bandwidth
Select
Delete
Select All
Select None

17.4.1 Bandwidth Port Setup Screen

Use this screen to set up multicast bandwidth requirements for specific ports. To open this
screen, click Advanced Application, IGMP, Bandwidth Setup, Port Setup.

Figure 71 Bandwidth Port Setup

IES-612-51A User's Guide
DESCRIPTION
Click Apply to save your changes to the IES-612-51A's volatile memory. The
IES-612-51A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Select a unique number for this setting. If you select a number that is already
used, the new setting overwrites the old one when you click Apply.
Enter the beginning of the multicast range.
Enter the end of the multicast range. For one multicast address, enter the start
of the multicast range again.
Enter the bandwidth requirement for the specified multicast range.
Click Apply to save the filter settings. The settings then display in the summary
table at the bottom of the screen.
Clicking Apply saves your changes to the IES-612-51A's volatile memory. The
IES-612-51A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring the fields afresh.
This table shows the multicast range settings.
This field displays the number that identifies this setting.
This field displays the beginning of the multicast range.
This field displays the end of the multicast range.
This field displays the allowed bandwidth for the specified multicast range.
Select this, and click Delete to remove the setting.
Click this to remove the selected settings.
Click this to select all entries in the table.
Click this to un-select all entries in the table.
Chapter 17 IGMP
157