Ppvc Setup Members Screen; Figure 54 Ppvc Setup, Edit - ZyXEL Communications IES-612-51A User Manual

Chapter 13 xDSL Port Setup
Table 23 PPVC Setup (continued)
LABEL
Show Port
Index
Port
VPI/VCI
Encap
PVID
Priority
Members
Delete

13.11.1 PPVC Setup Members Screen

Use this screen to add and remove member PVCs.
The member PVCs must be created on the subscriber's device.
To open this screen, click Basic Setting, xDSL Port Setup, PPVC Setup. Then, click a
PPVC's member number to open the PPVC Setup Members screen.

Figure 54 PPVC Setup, Edit

122
DESCRIPTION
Select the number of an ADSL port for which to display PPVC settings (or
display all of them).
This field displays the number of the PPVC.
This field displays the number of the ADSL port on which the PPVC is
configured.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier
(VCI). The VPI and VCI identify a channel on this port. The IES-612-51A uses
this PVC channel internally. This PVC is not needed on the subscriber's device.
This field displays the PPVC's type of encapsulation (llc or vc).
This is the PVID (Port VLAN ID) assigned to untagged frames or priority frames
(0 VID) received on this channel.
This is the priority value (0 to 7) added to incoming frames without a (IEEE
802.1p) priority tag.
This field displays how many PVCs belong to this PPVC has. Click the number
to open a screen where you can configure the PPVC's member PVCs.
Click Delete to remove a PPVC.
Clicking Delete saves your changes to the IES-612-51A's volatile memory.
The IES-612-51A loses these changes if it is turned off or loses power, so use
the Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
IES-612-51A User's Guide