Mac Filter Enable Command; Mac Filter Disable Command; Mac Filter Mode Command; Figure 162 Mac Filter Enable Command Example - ZyXEL Communications IES-612-51A User Manual

Chapter 46 MAC Commands

46.2.2 MAC Filter Enable Command

Syntax:
ras> switch mac filter enable [portlist]
where
[portlist]
This command turns on the MAC filtering feature on the specified DSL port(s) or on all DSL
ports if no port is specified.
The following example turns on the MAC filtering feature on DSL port 5.

Figure 162 MAC Filter Enable Command Example

ras> switch mac filter enable 5

46.2.3 MAC Filter Disable Command

Syntax:
ras> switch mac filter disable [portlist]
where
[portlist]
This command turns off the MAC filtering feature on the specified DSL port(s) or on all DSL
ports if no port is specified.
The following example turns off the MAC filtering feature on DSL port 5.

Figure 163 MAC Filter Disable Command Example

ras> switch mac filter disable 5

46.2.4 MAC Filter Mode Command

Syntax:
ras> switch mac filter mode <port> <accept|deny>
where
<accept|deny>
308
You can specify a single DSL port <1>, all DSL ports <*>
=
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
= You can specify a single DSL port <1>, all DSL ports <*>
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
accept = Only allow frames from MAC addresses that you
=
specify and block frames from other MAC addresses.
deny = Block frames from MAC addresses that you specify
and allow frames from other MAC addresses.
IES-612-51A User's Guide