Table 11 System Info - ZyXEL Communications IES-612-51A User Manual

Chapter 7 System Information
The following table describes the labels in this screen.

Table 11 System Info

LABEL
System Name
ZyNOS F/W Version This field displays the version number of the device's current firmware including
DSP Code Version
Hardware Version
Serial Number
Ethernet Address
Hardware Monitor
Enable
Temperature Unit
Temperature
Current
MAX
MIN
Average
Threshold (Low)
Threshold (Hi)
Status
Voltage(V)
Current
MAX
MIN
Average
Threshold (Low)
Threshold (Hi)
Status
New threshold
Apply
Temperature (Hi)
Temperature (Lo)
88
DESCRIPTION
This field displays the device's model name.
the date created.
This field displays the Digital Signal Processor firmware version number. This is
the modem code firmware.
This is the version of the physical device hardware. This field may be blank.
This is the individual identification number assigned to the device at the factory.
This field may be blank.
This field refers to the Ethernet MAC (Media Access Control) address of the
device.
Select this check box to turn the hardware monitor on or clear it to turn the
hardware monitor off.
Select C to display all temperature measurements in degrees Celsius. Select F
to display all temperature measurements in degrees Fahrenheit.
Each temperature sensor can detect and report the temperature. Temperature
sensor 1 is near the DSL chipset. Temperature sensor 2 is near the central
processing unit. Temperature sensor 3 is at the hardware monitor chip.
This shows the current temperature at this sensor.
This field displays the maximum temperature measured at this sensor.
This field displays the minimum temperature measured at this sensor.
This field displays the average temperature measured at this sensor.
This field displays the lowest temperature limit at this sensor.
This field displays the highest temperature limit at this sensor.
This field displays Normal for temperatures below the threshold and Over for
those above.
The power supply for each voltage has a sensor that can detect and report the
voltage.
This is the current voltage reading.
This field displays the maximum voltage measured at this point.
This field displays the minimum voltage measured at this point.
This field displays the average voltage measured at this sensor.
This field displays the lowest voltage limit at this sensor.
This field displays the highest voltage limit at this sensor.
Normal indicates that the voltage is within an acceptable operating range at this
point; otherwise Abnormal is displayed.
Use this section of the screen to configure the hardware monitor threshold
settings.
Configure new threshold settings in the fields below and click Apply to use
them.
Use these fields to configure the highest temperature limit at each sensor.
Use these fields to configure the lowest temperature limit at each sensor.
IES-612-51A User's Guide