Rpvc Arp Agingtime Show Command; Rpvc Arp Show Command; Rpvc Arp Flush Command; Figure 280 Rpvc Arp Agingtime Command Example - ZyXEL Communications IES-612-51A User Manual

where
<sec>
This command configures how long the device stores the IP addresses of CPE devices using
2684 routed mode in the Address Resolution Protocol table.
The following example sets the device to store the IP addresses 2684 routed mode gateways in
the Address Resolution Protocol table for 500 seconds.

Figure 280 RPVC ARP Agingtime Command Example

ras> adsl rpvc arp agingtime set 500

53.7.12 RPVC ARP Agingtime Show Command

Syntax:
ras> adsl rpvc arp agingtime show
This command displays how long the device stores the IP addresses of 2684 routed mode
gateways in the Address Resolution Protocol table.
The following is an example.

Figure 281 RPVC ARP Agingtime Show Command Example

ras> adsl rpvc arp agingtime show
rpvc aging time (sec): 500

53.7.13 RPVC ARP Show Command

Syntax:
ras> adsl rpvc arp show
This command
gateways in the Address Resolution Protocol table.
The following is an example.

Figure 282 RPVC ARP Agingtime Show Command Example

ras> adsl rpvc arp show
gateway ip
---------------
192.168.10.102

53.7.14 RPVC ARP Flush Command

Syntax:
ras> adsl rpvc arp flush
IES-612-51A User's Guide
Chapter 53 Virtual Channel Management Commands
The number of seconds (10~10000) the device is to keep the
=
Address Resolution Protocol table's entries of IP addresses
of 2684 routed mode gateways. Use 0 to disable the aging
time.
displays how long the device stores the IP addresses of 2684 routed mode
vid mac
---- -----------------
1 00:0d:9d:d9:43:3b
391