Log Messages; Table 90 Log Messages - ZyXEL Communications IES-612-51A User Manual

Chapter 42 Command Examples
Table 89 Log Format (continued)
LABEL
<type>
<log message>

42.3.1 Log Messages

The following table lists and describes the system log messages.

Table 90 Log Messages

LOG MESSAGE
ADSL <port> Link
Up(SN=<seq no>): <ds
rate>/<us rate>!
or
ADSL Link Info: NM:<ds
NM>/<us NM>!
ADSL <port> Link
Down(SN=<seq no>)!
ADSL <port> Link Loss
of Power Dying-Gasp
Event!
Change time server to
none.
Change time server to
TIME. IP:<ip>
Timezone: <time zone>.
Change time server to
DAYTIME. IP: <ip>
Change time server to
NTP. IP: <ip>
Timezone: <time zone>
Ether <port> Link
Down(SN=N)!
Ether N Link Up(SN=N):
<speed>!
Incorrect Password!
Session Begin!
Session End!
278
DESCRIPTION
This identifies what kind of log it is. "INFO" identifies an information log. "WARN"
identifies a warning log.
This is the log's detailed information (see
TYPE DESCRIPTION
An ADSL port established a connection.
INFO
<port> - port number
<seq no> - sequence number of the connection
<ds rate> - downstream rate
<us rate> - upstream rate
<us NM> - upstream noise margin
<ds NM> - downstream noise margin
An ADSL port lost its connection.
WARN
<port> - port number
<seq no> - sequence number of the connection
The subscriber device connected to an ADSL port experienced a loss of
WARN
power (Dying-Gasp).
<port> - port number
The time server setting was changed to none.
INFO
The time server protocol setting was changed to TIME. The time server's IP
INFO
address and time zone are displayed.
The time server protocol setting was changed to DAYTIME. The time
INFO
server's IP address and time zone are displayed.
The time server protocol setting was changed to NTP. The time server's IP
INFO
address and time zone are displayed.
An Ethernet link is down.
WARN
<port> - 1 is ENET1, 2 is ENET2
SN - an internal sequencer number
An Ethernet link is up.
INFO
<port> - 1 is ENET1, 2 is ENET2
SN - an internal sequencer number
<speed> - Ethernet connection speed, for example 1000M or 100M
Someone attempted to use the wrong password to start a console, telnet or
WARN
FTP session (see the <process> field for the type of session).
A console, telnet or FTP session has begun (see the <process> field for the
INFO
type of session).
A console telnet or FTP session has terminated (see the <process> field for
INFO
the type of session).
Table 90 on page 278)
IES-612-51A User's Guide