Service Access Control Screen; Figure 102 Service Access Control; Table 54 Snmp; Table 55 Service Access Control - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51 User's Guide
The following table describes the labels in this screen.

Table 54 SNMP

LABEL
Return
Get Community
Set Community
Trap Community
Trap Destination 1~4
Port
Trusted Host
Apply
Cancel

31.5 Service Access Control Screen

To open this screen, click Advanced Application, Access Control, Service Access Control.

Figure 102 Service Access Control

The following table describes the labels in this screen.

Table 55 Service Access Control

LABEL
Return
Services
198
DESCRIPTION
Click Return to go back to the previous screen.
Enter the get community, which is the password for the incoming Get- and
GetNext- requests from the management station.
Enter the set community, which is the password for incoming Set- requests from
the management station.
Enter the trap community, which is the password sent with each trap to the
SNMP manager.
Enter the IP address of a station to send your SNMP traps to.
Enter the port number upon which the station listens for SNMP traps.
A "trusted host" is a computer that is allowed to use SNMP with the IES-1248-
51.
0.0.0.0 allows any computer to use SNMP to access the IES-1248-51.
Specify an IP address to allow only the computer with that IP address to use
SNMP to access the IES-1248-51.
Click Apply to save your changes to the IES-1248-51's volatile memory. The
IES-1248-51 loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Click Return to go back to the previous screen.
Services you may use to access the IES-1248-51 are listed here.
Chapter 31 Access Control