Rpvc Route Delete Command; Rpvc Arp Agingtime Set Command; Figure 278 Rpvc Route Show Command Example; Figure 279 Rpvc Route Delete Command Example - ZyXEL Communications IES-612-51A User Manual

Chapter 53 Virtual Channel Management Commands
The following example displays the domains for 2684 routed mode traffic for devices
connected to DSL ports 1 and 2.

Figure 278 RPVC Route Show Command Example

ras> adsl rpvc route show 1,2
port vpi vci ip/netmask
---- --- --- ------------------
1
2

53.7.10 RPVC Route Delete Command

Syntax:
ras> adsl rpvc route delete <port number> <vpi> <vci> <ip>/<netmask>
where
<port number>
<vpi>
<vci>
<ip>
/<netmask>
This command removes a domain for 2684 routed mode traffic. The domain includes the
subscriber's LAN IP addresses.
The following example removes a domain for a CPE device is connected to DSL port 1 on the
IES-612-51A and the 2684 routed mode traffic is to use the PVC identified by VPI 8 and VCI
35. The CPE device's LAN IP address is 10.10.10.10 and uses a subnet mask of
255.255.255.0. This includes the CPE device's LAN IP addresses and the IP addresses of the
LAN computers.

Figure 279 RPVC Route Delete Command Example

ras> adsl rpvc route delete 1 8 35 10.10.10.1/24

53.7.11 RPVC ARP Agingtime Set Command

Syntax:
ras> adsl rpvc arp agingtime set <sec>
390
8 35 10.10.10.0/24
8 35 10.10.11.0/24
= The port of the RPVC. Specify a single DSL port <1>.
The VPI of the RPVC.
=
The VCI of the RPVC.
=
The subscriber's CPE LAN IP address in dotted decimal
=
notation.
The bit number of the subnet mask of the subscriber's IP
=
address. To find the bit number, convert the subnet mask to
binary and add all of the 1's together. Take "255.255.255.0"
for example. 255 converts to eight 1's in binary. There are
three 255's, so add three eights together and you get the bit
number (24).
IES-612-51A User's Guide