Advertisement
Router Modem >>
Status
1. PWR/SYS
2. LAN
3. WLAN
4. DSL
5. INTERNET
Port
5. Power/Switch
6. POWER
7. RESET
8. LAN
9. DSL
Procedures for Wireless ADSL Router
Lights and How to set up Wireless on Zyxel 660HW-T1 ADSL
front ADSL
lights status
Meanings
Power on/off
LAN connection
Wireless signal
ADSL connection
Wireless ADSL
Router can be
connected
Wireless ADSL Router back slots
Power on/off
Power Adapter jack
Reset to the factory settings (press and hold for 10 second)
UTP Ethernet cable RJ-45 LAN line ) for Internet connection
RJ-11 (phone line slot )
Normal light status
Green light
Orange light = 100M
Green light = 10M
Green light when
connected ADSL
Green light
Function
Abnormal light status
No light
No light
No light
Blinking green light
No light
Advertisement
Table of Contents
Related Manuals for ZyXEL Communications Prestige 600 Series
Summary of Contents for ZyXEL Communications Prestige 600 Series
- Page 1 Router Modem >> Lights and How to set up Wireless on Zyxel 660HW-T1 ADSL front ADSL lights status Status Meanings Normal light status Abnormal light status 1. PWR/SYS Power on/off Green light No light 2. LAN LAN connection Orange light = 100M No light 3.
- Page 2 1. Connect the power adapter with Wireless ADSL Router turn on the router 2. Connect a splitter with the Modem using a phone as shown 2.1 only 1 connection 2.2 if there are more than 1 connection 1 Micro filter musty be used...
- Page 3 3. There are 2 ways to connect computer to Wireless ADSL Router 3.1 through Wire line (RJ-45 LAN line)
- Page 4 3.2 through Wireless After the connection is completed the normal Wireless ADSL Router light status will be on go on with the configuration to access hi-speed Internet How to configure Wireless ADSL Router on web 1. Make sure the IP is as shown IP=192.168.1.X Subnet Mask 255.255.255.0 Default Gateway 192.168.1.1 2.
- Page 5 3. Click Wizard Setup > Connection Setup True Network parameters Parameter The correct one Encapsulation PPPoE LLC...
- Page 6 4. Set the parameters as shown then click “ Next” 5. Set your username and Password then click Next 6. click Save Settings...
- Page 7 7. click Start Diagnose to test the connection 8. Wait for the data to be loaded...
- Page 8 9. Once the testing is done a pop up will appear as shown Test your Ethernet Connection >test the connection to your computer if not ok, check the LAN line Test ADSL synchronization > test the ADSL signal. If not ok, check the signal line and the connection to the splitter Test PPP/PPPoE Server connection >...