ZyXEL Communications IES-612-51A User Manual page 64

Chapter 4 Introducing the Web Configurator
Table 4 Web Configurator Screens (continued)
LABEL
IP Setup
ENET Port Setup
xDSL Port Setup
xDSL Profiles Setup
xDSL Line Data
Advanced
Application
VLAN
IGMP
Static Multicast
Multicast VLAN
Filtering
MAC Filter
Spanning Tree
Protocol
Port Authentication
Port Security
DHCP Relay
DHCP Snoop
2684 Routed Mode
PPPoA to PPPoE
DSCP
TLS PVC
ACL
Downstream
Broadcast
SysLog
Access Control
Routing Protocol
Static Routing
Alarm
64
DESCRIPTION
Use this screen to configure the system and management IP addresses and
subnet masks.
Use this screen to configure settings for the Ethernet ports.
Use these screens for configuring settings for individual DSL ports.
Use these screens for configuring profiles for the DSL ports.
Use these screens for viewing DSL line operating values, bit allocation and
performance counters.
Use these screens for viewing and configuring the VLAN settings.
Use these screens to view IGMP status information and configure IGMP
settings and IGMP filters. You can also use these screens to set up bandwidth
requirements by multicast group or port and to set up limits on the number of
multicast groups to which a port can subscribe.
Use this screen to configure static multicast entries.
Use these screens to set up multicast VLANs that can be shared among
different subscriber VLANs on the network.
Use this screen to configure packet filtering.
Use this screen to configure MAC filtering for each port.
Use these screens to display Rapid Spanning Tree Protocol (RSTP) information
and configure RSTP settings.
Use these screens to configure RADIUS and IEEE 802.1x security settings.
Use this screen to limit the number of MAC address that can be learned on a
port.
Use this screen to configure the DHCP relay settings.
Use these screens to drop traffic from IP addresses not assigned by the DHCP
server and to look at a summary of the DHCP packets on each port.
Use this screen to configure the IES-612-51A to handle 2684 routed mode
traffic.
Use this screen to enable PPPoA-to-PPPoE conversions on each port.
Use this screen to set up DSCP on each port and to convert DSCP values to
IEEE 802.1p values.
Use this screen to set up Transparent LAN Service (VLAN stacking, Q-in-Q) on
each port.
Use this screen to set up Access Control Logic profiles and to assign them to
each PVC.
Use this screen to block downstream broadcast packets from being sent to
specified VLANs on specified ports.
Use this screen to configure the syslog settings.
Use this screen to configure service access control and configure SNMP and
remote management.
Use this screen to configure static routes. A static route defines how the IES-
612-51A should forward traffic by configuring the TCP/IP parameters manually.
IES-612-51A User's Guide