Static Routing; Chapter 35 Static Routing; Figure 118 Static Routing; Table 79 Static Routing - ZyXEL Communications IES-612-51A User Manual

C
H A P T E R
This chapter shows you how to configure the static routing function.
Static routes tell the IES-612-51A how to forward the IES-612-51A's own IP traffic when you
configure the TCP/IP parameters manually. This is generally useful for allowing management
of the device from a device with an IP address on a different subnet from that of the device's
IP address (remote management).
To open this screen, click Routing Protocol, Static Routing.

Figure 118 Static Routing

The following table describes the labels in this screen.

Table 79 Static Routing

LABEL
Name
Destination IP
Address
IP Subnet Mask
Gateway IP Address Enter the IP address of the gateway. The gateway is an immediate neighbor of
IES-612-51A User's Guide
DESCRIPTION
Use this section to create a new static route.
Type a name to identify this static route. Use up to 31 ASCII characters. Spaces
and tabs are not allowed.
This parameter specifies the IP network address of the final destination. Routing
is always based on network number. If you need to specify a route to a single
host, use a subnet mask of 255.255.255.255 in the subnet mask field to force
the network number to be identical to the host ID.
Enter the subnet mask for this destination.
your device that will forward the packet to the destination. The gateway must be
a router on the same segment as your device.

Static Routing

35
235