System Control Tasks Through Windows Of Pc Ui; System Control Tasks Through Command Line - Xerox 4635 Operator's Manual

SYSTEM CONTROL TASKS

System control tasks through windows of PC UI

System control tasks through command line

4-2
To select system control tasks using the windows of the PC UI:
1. Open the System Control menu icon.
The System Control menu window appears, listing the available
options.
Figure 4-1. System Control menu window
2. Turn to the section of this chapter which explains the task in
which you are interested.
Note: This chapter covers operator related tasks only. For
information on any of the options not covered in this
chapter, refer to the Xerox 4635 Laser Printing System PC
User Interface Reference.
You can perform system control tasks by entering commands
either:
• Through the Messages window of the PC UI
• Through the system controller terminal (non-U.S. markets
only).
To enter commands through the Messages window of the PC UI:
1. Place the cursor in the window.
2. Click once with the left mouse button.
3. Enter the command.
If you are using the system controller terminal, just use the
keyboard to enter the command.
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE