Paper Sizing And Print Jobs; Feeder Trays; Feeder Tray Features - Xerox 4635 Operator's Manual

PAPER FACTS

Paper sizing and print jobs

Feeder trays

Feeder tray features

3-8
The 4635 LPS feeder trays have edge guide sensors that detect
paper length and width. The LPS selects the correct feeder
tray(s) for the print job, based on the paper size specified in the
job.
• If an exact match is found, the print job proceeds.
• If an exact match is not found, depending on how the job
was set up, one of the following occurs:
— A message appears on the PC UI or system controller
display and the printer control console telling you to load
different paper or inquiring whether it is permissible to
print the job on paper that is larger than specified for the
job.
— The job prints on paper larger than specified for the job.
— The job is aborted.
Note: The LPS never prints a job on paper known to be
smaller than that specified for the job.
If you encounter any problems related to paper sizing, contact
your lead operator, systems specialist, or Xerox support
specialist.
Your LPS provides six feeder trays:
• Two processor feeder trays
• Four high-capacity feeder (HCF) trays.
(Refer to chapter 1, "System overview of the 4635 LPS," for
additional information on the available feeder trays.)
Up to six different stocks may be used within a print job,
including oversize covers or tabs.
Note: If your LPS is fitted with a bulk feeder, the number of
available stocks increases by one.
For instructions on selecting feeder trays and managing clusters
(groupings of trays), refer to chapter 9, "Status and print tasks."
• Any tray not currently in use can be opened, pulled out, and
loaded, without interrupting printing.
• If you try to open a tray currently in use, feeding switches to
a backup tray if one is available. If one is not available, the
printer stops.
• The printer does not feed all the paper out of a tray. (A
stack of approximately 1/4 inch/6 mm remains in the tray.)
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE