Xerox 4635 Operator's Manual page 90

SYSTEM CONTROL TASKS
Boot the LPS task through system
controller terminal
(non-U.S. markets only)
4-6
Figure 4-6. Boot button on the operator control panel
2. Select the option you want to use from the following:
• Operating System. Select this option to boot the LPS
from the system disk.
• System Disk. Select this option to access TEM. You can
then perform various system tasks, including SYSGEN.
• Reel to Reel. Select this option to boot the LPS from the
open-reel tape drive. This option switches you to TEM.
• QIC. Select this option to boot the LPS from the 1/4 inch
cartridge tape drive. This option switches you to TEM.
• 18 Track Tape. Select this option to boot the LPS from
the 1/2 inch cartridge tape drive. This option switches
you to TEM.
3. The full desktop appears after the system boot is completed.
To boot the LPS from the system controller terminal, follow this
procedure:
1. Press <B> for BOOT on the keyboard to load the operating
system software (OSS).
Note: The operating system software must be loaded before
the system can finish the warm-up cycle.
When loading is complete, the following messages appear on
the system controller display:
LOADING PROGRAM.......
XEROX [PRODUCT ID]
LASER PRINTING SYSTEM
VERSION X REVISION Y
DISK ID: [Thirty-character-ID-record]
ENTER DATE:MM:DD:YY
2. Key in the date, using numerals. You may use a space, a
colon (:), or a slash (/) between the month, day, and year.
Once you have entered the date, a written version is
displayed, that is, 1/23/95 becomes January 23, 1995.
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE