Installing The Custom Transfer Assist Blade; Setting Tray Size With The Custom Transfer Assist Blades - Xerox 4635 Operator's Manual

Installing the custom transfer assist blade

Setting tray size with the custom transfer assist blades

U.S. markets
11.5 to 11.7 inches/292 to 297 mm
12.1 to 12.9 inches/307 to 328 mm
13 to 13.9 inches/330 to 353 mm
Non-U.S. markets
10 to 10.9 inches/254 to 277 mm
11.5 to 11.6 inches/292 to 294 mm
12.1 to 12.9 inches/307 to 328 mm
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
The custom transfer assist blade comes in a package containing
detailed instructions. Be sure to follow the instructions carefully.
CAUTION: To prevent damage to the LPS, have your service
representative show you the procedure before you attempt to
customize and install a custom transfer assist blade for the first
time.
When you are using the custom transfer assist blade, you must
set the tray length differently than described in the "Set tray size"
section of chapter 9. Use table 11-1 to determine the tray length
setting to use.
Table 11-1. Tray length settings for custom transfer assist
blades
—Set tray size to 11.7 inches/297 mm
—Set tray length to 13 inches/330 mm
—Set tray length to 14 inches/356 mm
—Set tray length to 11 inches/279 mm
—Set tray length to 11.7 inches/297 mm
—Set tray length to 13 inches/330 mm
Note: Set the tray width to the width of the custom paper.
MAINTENANCE TASKS
11-23