Faults Are Cleared But The Attention Light Is Still On; Printing Does Not Continue When The Continue Button Is Pressed - Xerox 4635 Operator's Manual

Faults are cleared but the Attention light is still on

Printing does not continue when the Continue button is pressed

XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
3. Relatch the paper feeder assembly by pressing down on the
bright green dot. Slide the paper tray completely back into
the printer.
Figure 12-33. Relatching the paper feeder assembly
4. Operate the system as usual. If you are still experiencing
misfeeds, place a service call.
Notes:
1. This procedure should be used only to correct a
problem, not as a routine maintenance procedure.
Because the belts are made of rubber, frequent cleaning
with film remover will dry them out and cause them to
fail prematurely.
2. Film remover may be obtained from your Xerox service
representative.
If you have cleared all faults that are listed on the printer control
console, but the Attention light is still on and the message
"Output is stopped. See message at the System Display" appears
on the printer control console, there may be an uncleared output
fault. Check the PC UI Command Line/Message window or an
opened window for an output message (preceded by an asterisk
and OS followed by a number). Follow the instructions in the
output message and press the Continue button.
If the Continue button is pressed before all printer faults are
cleared, the outstanding faults are changed to the status of
masked faults (refer to the "Fault masking and the printer control
console" section earlier in this chapter). If the printer status
displayed in the message area of the printer control console is
READY, but printing does not continue when you press the
Continue button, touch the Fault List icon on the printer control
console to display the Fault List screen. (Refer to figure 12-1.)
Clear any faults displayed on this screen and press the Continue
button again.
PROBLEM SOLVING TASKS
12-25