PROBLEM SOLVING TASKS
Cleaning the feed belt
12-24
1. Clear any misfeeds that have occurred, but do not relatch the
paper feeder assembly. The paper feeder assembly must be
unlatched to clean the belt; if necessary, unlatch it by
pressing down on the bright green lever on the right side of
the paper tray.
Figure 12-31. Unlatching the paper feeder assembly
2. Lightly moisten a lint-free towel with Xerox recommended
film remover and wipe the outside surface of the feed belt
thoroughly in the same direction as the ribs on the belt.
(Wiping from side to side might pull the belt off its track.)
Allow a few seconds for the film remover to evaporate.
Figure 12-32. Cleaning the feed belt
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE