Xerox 4635 Operator's Manual page 233

XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
CARTRIDGE The 1/2 inch cartridge tape drive.
You may set the tape density to either 1600 (default setting)
or 6250 bpi.
COPY {TAPE|CARTRIDGE|TDn}WRITE[/BF:n]LABEL
[disk-id] {input-file-id [output-file-id|ALL|file-type]}
TAPE WRITE LABEL Indicates the files are to be written to
an LPS-labeled tape.
CARTRIDGE WRITE Indicates the files are to be written
LABEL to a labeled cartridge tape.
TDn WRITE LABEL Indicates the files are to be written to
the specified tape device.
/BF:n The capability to pack n disk blocks
into one tape block. n can have a
value of 1 to 16. The size of the tape
block, in bytes, resides in the tape
label. The default blocking factor is 1.
The label indicates the blocking factor.
This parameter is optional.
disk-id Tells which disk (DP0:, DP1:, DP2:, or
DP3:) from which the file is to be
written. Keying in this parameter is
not necessary unless you want the file
to be written from a specific system
disk.
input file-id Gives the name of the system disk file
to be copied to tape.
output file-id Provides the name to be given to the
output tape file, using the following
form: file-name.file-type. If no output
file id is specified, the system disk file
name is used for the tape file.
ALL Indicates that all user files are to be
copied to tape.
file-type Specifies the name of a directory, such
as FRM, FNT, IMG. All the files in that
directory are written to tape.
FILE CONTROL TASKS
10-9