Xerox 4635 Operator's Manual page 119

JOB CONTROL TASKS
Figure 5-5. Sample test form
4. If further adjustments are needed, repeat steps 2 and 3 until
you are satisfied with the results.
There is another method used to set alignment with the system-
generated test pattern. Enter the ALIGN command with the new
values, followed immediately (no spaces) by, TEST (for example,
ALIGN 3,8,TEST). This command sets the new values and
automatically generates a single test form sample for your
evaluation. The new values are printed near the top of the form.
The ALIGN, TEST command may be used any time you wish to
generate a sample test form with the current values printed on it.
(You could use this command in step 1, instead of the basic
ALIGN command.)
Note: Remember to restore the printer to its original values.
Enter ALIGN and the original values, whatever they were at the
beginning. Refer to step 1.
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE 5-7