Xerox 4635 Operator's Manual page 127

Sample Files task through
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
4. Select the appropriate header button:
command line • To print a sample of a form, font, logo, or graphic stored on
the system disk, enter the following command:
SAMPLE file-name.file-type [,D,copies]
file-name
file-type
D
copies
Note: For prints of graphics only, you may be asked to use
the HARDCOPY command instead of the SAMPLE command.
There is no difference in the graphic, but the data sheet that
is printed with it is more detailed when the HARDCOPY
command is used.
• To print samples of all files of a certain type, such as font,
form, and logo files, specify the type only. Enter the
following command:
SAMPLE .file-type [,D,copies]
file-type
• To specify the units used for the vertical and horizontal
positioning of the image, select the unit from the
auxiliary menus next to the Vertical and Horizontal
Units fields. The default value of the field is inches.
• If you want to print more than one copy of the file
specified, enter the number in the Copies field.
Note: The maximum number of copies you can print
is 32,767.
• If you want the samples to print on both sides of each
sheet of paper, select the duplex option from the
Format field's auxiliary menu. Otherwise, the samples
print on only one side of the paper (simplex).
• Apply/Close. Apply your selection and close the
window.
• Apply. Apply your selection.
• Close. Close the window.
The name of the file, obtained from your
systems personnel.
Either:
• .FRM (form)
• .FNT (font)
• .IMG (graphic)
Print the samples on both sides of each sheet
of paper (duplex mode). If you do not enter a
D, the samples print on only one side of each
sheet of paper (simplex mode).
The number of copies you want. If you do not
enter a number, one copy is printed.
Either:
• .FRM (form)
• .FNT (font)
• .IMG (graphic)
JOB CONTROL TASKS
5-15